EcoRenovator - View Single Post

pinballlooking · 01-28-18, 11:17 PM

The head now has valves/seals and lifters/cam shafts.

It is ready to go on the block. It is wrapped in plastic until then.
All the piston rods and main bearing caps are cleaned up.

One more step done.

I had two helpers today.

The T-Bore Hole Gauges are not good at all. Very hard to get a good reading form these.
I would not recommend getting theses.

01-28-18, 11:17 PM	#50
pinballlooking Super Moderator Join Date: Jun 2013 Location: SC Posts: 2,923 Thanks: 172 Thanked 564 Times in 463 Posts	The head now has valves/seals and lifters/cam shafts. It is ready to go on the block. It is wrapped in plastic until then. All the piston rods and main bearing caps are cleaned up. One more step done. I had two helpers today. The T-Bore Hole Gauges are not good at all. Very hard to get a good reading form these. I would not recommend getting theses. Attached Images __________________ Current project Aquaponics system , Passive Solar Greenhouse build To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Solar Install 12.5 Kwh- To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Mini Split installs - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. EV Chevy Volt - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Last edited by pinballlooking; 02-01-18 at 09:05 AM..